Antelope Zodiac+ Ower's Manual page 9

MODES:
UF1 – USB Full Speed Mode (12Mbits) for backwards compatibility. Supports sample rates
up to 96KHz.
Uh1 – USB High Speed Mode (480Mbits). USB Audio Class 1.0. Sample rates up to 192KHz
(default).
Uh2 – USB High Speed Mode (480Mbits). USB Audio Class 2.0. Sample rates up to 384KHz
(OS X and Linux only).
How to change mode...
1. Enter standby mode by pressing power button (7); Display (5) will go off signifying
standby mode.
2. Press and hold source button (9) until display (5) appears.
3. Toggle source button (9) until desired mode appears
4. Press power button (7) to bring the unit back into operational state.
8. Power/Standby light
Indicates operational and standby modes. Dimly lit for standby and brightly lit for operational power.
9. Source button
Toggle for selecting source on all rear panel inputs. The selection is shown on the display (5). Only
valid rear panel connections are given as an option. Example: If only AES and TOSLINK 1 are
connected, they will be the only options available when selecting the source.
The source button is also used to select the USB mode. See Power Button (7).
10. Mono Button
Pressing the mono button activates the summed outputs to give mono on the analog and headphone
outputs. The status of the mono function is indicated by the mono light (3).
11. Mute
Dual function mute: Press once for -40db dim and press again for full mute. The display (5) also
changes brightness when using the mute options.
12. Headphone Outputs
Universal ¼" Stereo Headphone jacks for connecting headphones of wide ranging impedances.
1
10