Cleaning External Surfaces; Replacing The Uv Lamp - Therapure 201M Owner's Manual

10
cleaning & maintenance
NOTE:
»
vacuuming will restore performance of the Permanent HEPA type Filter. However, the
filter may appear stained. This is normal and does not affect performance in any way.
»
Do not use water or any household cleaners or detergents to clean the Permanent HEPA
type Filter.
»
The Permanent HEPA type Filter has been designed to never need replacing. However, it
does need servicing. We recommend that under normal conditions of continuous use, the
filters be cleaned every month to maintain optimal functioning.
»
The inlet grill may be cleaned (after unit is turned off and unplugged) with a vacuum
or a slightly damp cloth.
Uv lamp
The lifetime of the UV lamp is up to 18 months of continuous, effective operation. After this time,
the bulb may remain illuminated, but its effectiveness is greatly reduced. For maximum germicidal
protection, please replace the UV bulb annually.
If the lamp stops functioning, please call 1.800.875.8577 to order a replacement lamp.

Cleaning External Surfaces

1. Turn off and unplug unit.
2. Use a washcloth slightly dampened with a little water and dishwashing soap to wipe
the outer case surfaces.
3. Do not allow water to slip into the internal parts as this could damage your unit and result
in electrical shock and injury to you.
4. Allow the unit to thoroughly dry before use.
cleaning & maintenance
Before replacing the Uv lamp, make sure your Therapure
is turned off and unplugged.

Replacing the Uv Lamp:

1. Take out the 2 screws which are used to peg the cover from the bottom of the unit,
and then remove the cover.
2. Pull out the UV lamp base assembly from the bottom of the unit.
3. Pull out the old UV lamp from the lamp base assembly.
4. Install the new UV lamp into the lamp base assembly.
5. Install the UV lamp base assembly into the unit. Make sure the UV lamp base assembly
snaps into place.
6. Install the cover and the 2 screws.
1.
3.
5.
11
® air purifier
2.
4.
6.
201M