Set Up Easylink (Hdmi-Cec Control) - Philips HTB4150B User Manual

Option 1: Connect audio through a
digital optical cable
Best quality audio
1
Using an optical cable, connect the
OPTICAL IN connector on your
SoundStage to the OPTICAL OUT
connector on the TV or other device.
• The digital optical connector might be
labeled SPDIF or SPDIF OUT.
Option 2: Connect audio through a
digital coaxial cable
Good quality audio
1
Using a coaxial cable, connect the
COAXIAL IN connector on your
SoundStage to the COAXIAL/DIGITAL
OUT connector on the TV or other
device.
• The digital coaxial connector might be
labeled DIGITAL AUDIO OUT.
10 EN
Option 3: Connect audio through
analog audio cables
Basic quality audio
1
TV
Set up EasyLink (HDMI-CEC
control)
This SoundStage supports Philips EasyLink,
which uses the HDMI-CEC (Consumer
Electronics Control) protocol. EasyLink-
compliant devices that are connected through
HDMI can be controlled by a single remote
control.
•
•
Before you start
•
•
Using an analog cable, connect the AUX
IN connector on your SoundStage to the
AUDIO OUT connectors on the TV or
other device.
Note
Depending on the manufacturer, HDMI-CEC is known
by many names. For information on your device, see
the user manual of the device.
Philips does not guarantee 100% interoperability with
all HDMI-CEC devices.
Connect your SoundStage to the HDMI-
CEC compliant device through HDMI
connection.
Make the necessary connections described
in the quick start guide, and then switch
the TV to the correct source for your
SoundStage.
VCR