Page 1
Register your product and get support at www.philips.com/welcome User manual Mode d'emploi Manuale utente Manual del usuario Manual do utilizador...
If you press the middle of the switch once more, source OSD will be displayed. If you press the middle of the switch and hold about a few seconds, the TV will switch to standby mode. Main menu OSD cannot be displayed via control buttons.
3. Play (in Media Browser mode) / Play-Slideshow (in Media Browser) 4. Rapid reverse (in Media Browser mode) 5. AV / Source selection 6. TV 7. Electronic programme guide(in DVB channels) 8. Navigation buttons (Up/Down/Left/Right) 9. Programme recording 10. Programme Down / Page up 11.
| When using the wall mounting kit (optional), we recommend that you plug all your cables into the back of the TV before mounting on the wall. | Insert or remove the CI module only when the TV is SWITCHED OFF. You should refer to the module instruction manual for details of the settings.
TV will then switch on. (*) LCN is the Logical Channel Number system that Note: If you switch on your TV via CH- or CH+ buttons on organizes available broadcasts in accordance with a the remote control or on the TV set, the programme that you recognizable channel sequence (if available).
Media Playback via USB Input You can connect a USB hard disk drive or USB memory stick to your TV by using the USB inputs of the TV. This feature allows you to play files stored in a USB drive. 2.5” and 3.5”...
PC mode) dot intensive presentations like spreadsheets or paragraphs or text in smaller fonts. Depending on the resolution and scan frequency that you input to the TV set, you Phase (in PC may see a hazy or noisy picture on the screen. In such a case you can use this item mode) to get a clear picture by trial and error method.
Page 8
Sets digital out audio type. Using the Channel List Configuring Parental Settings The TV sorts all stored stations in the Channel List. You To prohibit viewing of certain programmes, channels and menus can edit this channel list, set favourites or set active can be locked by using the parental control system.
Page 9
Manual, Time Zone will be enabled. * If the TV is switched to standby mode and switched on later and there is no broadcast available, time information will not be updated. If there is a present broadcast;...
Page 10
TV Menu Features and Functions To ensure that your TV always has the most update information, you can use this Software Upgrade setting. In order for the proper operation, please ensure that the TV is set to standby mode. Application Version Displays application version.
IMPORTANT: To record a programme, you should first computer; however, these files will not be available to be connect a USB disk to your TV while the TV is switched off. played on a computer. You can play the recordings only You should then switch on the TV to enable recording feature.
Around 5 minutes later TV restarts with new software activated. The TV may start in first time installation mode. Recording Configuration • If your TV fails to restart in 10 minutes, unplug power...
You should then switch on the TV to enable Try turning off the TV for a while. To avoid this, do not recording feature. Otherwise, recording feature will leave the screen in still picture mode for extended periods.
When connecting devices to your TV’s connectors by using DVI to HDMI The following table is an illustration of some of the typical video display modes. Your TV may not support all resolutions. Your TV supports up to 1920x1080. cables (not supplied), you can refer to the following resolution information.
(X: Not Available, O: Available) In some cases a signal on the LED TV may not be displayed properly. The problem may be an inconsistency with standards from the source equipment . If you do experience such a problem please contact your dealer and also the manufacturer of the source equipment.
Page 17
All registered and unregistered trademarks are the property of their respective owners. Specifications are subject to change without notice. Philips and the Philips’ shield emblem are registered trademarks of Koninklijke Philips Electronics N.V. and are used under license from Koninklijke Philips Electronics N.V.