Recording Level Menu 9 - HHB FlashMic DRM85 User Manual

Recording Level Menu
This menu will not be available if 'Enable Configuration changes in DRM' was set to 'No'
when the configuration file was defined in FlashMic Manager.
The audio level used during recording will be that defined within FlashMic Manager for the
preset being used. The Recording Level menu permits this level to be altered.
To enter the Recording Level Menu, enter MENU mode by pressing the M/STOP button,
and then make SHORT DOWN TURNs of the jogswitch until the display shows
Select this with a SHORT PRESS, and the display shows either
current level – or
RV AGC
current preset.
The recording level can now be adjusted with SHORT UP or DOWN TURNS. A SHORT
PRESS selects the new level.
The units used are in dBs; 0 = min, 40 = max.
When the record level is reduced to 'zero', the AGC system is selected.
In this mode, FlashMic automatically adjusts recording level according to the sound level.
In most situations, this ensures that a recording of usable level will be made, but as with
all automatic gain systems, a degree of background noise "pumping" may be audible on the
recording.
It is also possible to adjust the FlashMic's recording level whilst recording. See Adjusting
Record Level on page .
Note that the record level always resets to the last value used when the FlashMic is
switched on, and not to the value set as part of the preset.
RECLEV
Record Level Menu Display
if automatic adjustment of recording level was defined for the
RVOL34
Record Level Setting
RV AGC
Record Level Set To AGC
.
RECLEV
- where nn = the
RVOLnn
En.9