Maytag LAT9206 User Manual page 8

Hide thumbs Also See for LAT9206:
Table of Contents

Advertisement

Care
and Cleaning
...............................................
Turn off the water faucets after finishing the day's wash-
Interior
- hard water deposits may be removed, if
ing. This will shut off the water supply to the washer
needed, using a recommended cleaner labeled wash-
and prevent the unlikely possibility of damage from
er safe.
escaping water.
Lint Filter - these are self-cleaning and require no
Use a soft cloth to wipe up all detergent, bleach or other
maintenance. They are located under the agitator on
spills as they occur,
the bottom of the washtub.
During the wash and
rinse portion of
Clean the following as recommended:
the cycle, lint is
Control Panel - clean with a soft, damp cloth and glass
collected on the
cleaner.
Do not use abrasive powders or cleaning
filters. Then dur-
pads.
ing the spin and
drain the filters
Cabinet - clean with soap and water followed with an
are cleaned auto-
appliance wax, if desired.
matically.
Storing
the Washer .............................................
Washers can be damaged if water is not removed from
• Advance the cycle control knob to Spin and lower the
hoses and internal components before storage. Prepare
drain hose to eliminate any water that may be in the
the washer for storage as follows:
drain hose.
• Select the NORMAL cycle for regular fabrics and add
• Disconnect the washer from the electrical supply and
one cup of bleach or white vinegar to a full load of
leave the washer lid open to let air circulate inside the
water without clothes.
Run the washer through a
tub.
complete cycle.
• Turn the water faucets off and disconnect the inlet
hoses.
Water
Use .............................................................
PERMANENT PRESS CYCLE
REGULAR CYCLE

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lat8106Lat8016Lat8026Lat8006Lat1916

Table of Contents