LG 55WV70MS Owner's Manual page 50

IP Environment Setup (Cont.)
Wired Network Connection
1. The next Network Connection window will enable you to specify
the IP and DNS configuration for this TV. Auto (DHCP) tabs will
be selected by default. If a DHCP server is configured and a
static configuration is not required, you can simply select OK
(on the screen) and then press OK on the Installer Remote.
The DHCP server will assign an IP address and DNS server to
the TV once the TV successfully connects to the network.
Otherwise, use the arrow keys to select the Static tab(s), and
specify the static configuration data for both the IP and DNS
modes. When all fields are completed, select OK (on the
screen) and press OK on the Installer Remote.
Note: You can specify a static DNS server with an auto-
configured IP address but not vice versa.
The TV will attempt to connect to the network and you will
see a progress screen that indicates status as each network
element is confirmed (see example at right). If the network
is connected successfully, a "Wired network is connected"
message will be displayed at the top of the screen and the
network configuration data will be displayed in the lower half
of the screen.
2. Select Complete (if not already selected), and then press OK
on the Installer Remote to exit the Network Connection wizard
and return to the IP Environment Menu.
Note: If the network connection is not successful, the progress
screen will identify the network element in which the connection
failed. Check your cabling and/or, if necessary, press
Installer Remote to return to the Configure IP and DNS Modes
screen to verify the configuration data.
Wireless Network Connection
1. In the next Network Connection window, use the arrow keys on
the Installer Remote to select the type of wireless connection to
configure and press OK.
• AP List: Select from a list of available access points.
• Enter the SSID: Direct enter the SSID of an access point
whose SSID has not been enabled for broadcast (i.e., the
access point does not appear in the AP List).
• WPS-PBC: Connect to a network via an access point that is
enabled for PBC.
• WPS-PIN: Complete network/PIN verification via the
access point web interface.
• Ad-hoc: Connect to a network via a Wi-Fi device, such as a
PC, mobile phone, etc.
50
Network Connection
Network Connection
on the
Network Connection
Configure IP and DNS modes.
Auto (DHCP) or Static
IP Mode Auto (DHCP) Static
IP Address
0 0
Subnet Mask 0
0 0
Gateway 0 0 0
DNS Mode Auto (DHCP) Static
DNS Server
0 0
OK
Wired network is connected.
TV Gateway DNS
MAC Address : AA:BB:CC:DD:EE:23 Gateway : 10.10.10.10
IP Address : 10.2.3.4 DNS Server : 10.5.6.7
Subnet Mask : 255.255.255.0
Complete
Select the type of wireless network connection.
AP List
AAA
BBB
Enter the SSID
CCC
DDD
WPS-PBC
EEE
WPS-PIN
Choose from APs to connect to the network.
Ad-hoc
(Continued on next page)
0 0
0
0
0 0
Internet
206-4214