Hitachi N 5024A2 Instruction And Safety Manual page 17

2) the Stapler is always held firmly against
the workpiece.
If staples are driven too deep or shallow into
the workpiece, adjust the stapling in the
following order.
1 DISCONNECT
STAPLER.
Adjuster
2 If staples are driven too deep, turn the
adjuster to the shallow side.
If staples are driven too shallow, turn the
adjuster to the deep side.
2
Turn adjuster
Too deep
2
Turn adjuster
Too shallow
3 Stop turning the adjuster when a suitable
position is reached for a stapling test.
4 Connect the air hose.
ALWAYS WEAR SAFETY GLASSES.
Perform a stapling test.
5 DISCONNECT
STAPLER.
6 Choose a suitable position for the
adjuster.
AIR HOSE FROM
15
Disconnect
air hose
Flush
Flush
AIR HOSE FROM
— 17 —
English