Default Configuration On The Local Area Network (Lan) Side - Sagem F@ST 1200 User Manual

Appendix D - Default configuration
This chapter gives the default parameter settings for the SAGEM F@st™ 1200 on
leaving the factory.
D.1 Default configuration on the local area network (LAN) side
The table below gives the values of the main default LAN parameters for your residential
gateway (ETH, USB):
LAN characteristics
ETH IP address
USB IP address
BROADCAST, ARP, MULTICAST
Router
NAT/PAT
SAGEM F@st™ 1200 User Guide - 252336343-01
Page D-2 Sagem Communication document. Reproduction and disclosure prohibited
Value
192.168.1.1/24 Internet and configurator access.
Activated
LAN traffic is routed to your ISP
Activated
Status