TO WASH ...................................................................................................................................
1. Before starting washing, check the following;
• Connect the water supply hose and open the water tap.
• Connect the power cord to the power supply outlet.
• Lay the drain hose(A) down toward a sinkhole.
• Place the drain hose(A) in sink or bath
about 70~80cm above the ground.
2. Set the WASH SELECTOR KNOB
to the desired mode.
'NORMAL or HEAVY'
3. Set the CYCLE SELECTOR KNOB to
'WASH . RINSE'. (In case no drain pump.)
('WASH' In case drain pump.)
(Without pump)
(With pump)
4. Set the WATER SELECTOR
KNOB to WASH .
5. Put the cloths into
the wash tub and
set the same water
tub so as not to
exceed 'H3'level.
WASHING PROCEDURE
6. Fill water in the wash
tub to the'' L1''lower
water level by carefully
adjusting the tap water
and add the detergent.
7. Set the WASH TIMER 1-35 minutes.
SOAK
(WITHOUT PUMP)
• Set the WASH TIMER
to the point more
than "15" for SOAK
function.
• If the WASH TIMER is
set to the point less
than "15", it leads to
WASH only. (No SOAK)
• If Although the machine may stay still
(WITH PUMP)
maximum 5 minutes, if the WASH
TIMER is indicated over 15 minutes
position, it is just in the process
of soaking and not a breakdown.
8. After washing,set the
CYCLE SELECTOR KNOB
to 'DRAIN' for drain.
9. Soak-Washing
1) Place clothes into the WASH TUB.
WASH TUB with desired amount of
water.
3) Put detergent depending on the
water volume and detergent
package indications.
4) Set WASH TIMER to point between
"15" to "35" in the timer.
• Soak-Washing automatically
starts the wash (15 min.) after the
soak (2 to 20 min.) is completed.
• The SOAK function (20 min.)
repeats the cycle that is
1.5 ~ 2.0 min. turning and
the next 5 min. resting 3 times.
4
Need help?
Do you have a question about the Washing machine and is the answer not in the manual?