Connecting The Speakers - Samsung HT-D555W User Manual

Installing the Speakers on the Tallboy Stand
1. Turn the Stand Base upside-down and connect it to
the Stand.
2.
Insert small screws (4*20, For connecting Stand & Stand
Base) clockwise into the four holes marked using a
screwdriver as shown in the illustration.
!
CAUTION : When you use a torque screwdriver, be
careful not to put excessive force. Otherwise, it runs
idle or can be damaged. (torque screwdriver- below 15
kg.f.cm)
3. Connect the upper Speaker to the assembled Stand.
4. Insert another large screw (5*15, For connecting Speaker
& Stand) clockwise into the hole on the rear of the
speaker using a screwdriver.
5. This is the appearance after the speaker is installed.
Follow this steps to install other speaker.

Connecting The Speakers

1. Press down the terminal tab on the back of the speaker.
2. Insert the black wire into the black terminal (–) and the red wire into the red
terminal (+), and then release the tab.
3. Connect the connecting plugs to the back of the product by matching the
colors of the speaker plugs to the speaker jacks.
4. With the product turned off, insert the TX card into the
TX Card Connection (WIRELESS) on the back of the product.
Hold the TX card so that the label "WIRELESS" faces upward and insert
•
the card into the port.
The TX card enables communication between the product and the
•
wireless receiver module.
5. Connect the left and right surround speakers to the wireless Receiver module.
6. Plug the power cord of the wireless Receiver module in the wall outlet .
1 2
Stand
Base
Stand
3 4
Speaker
Stand
5
Black
SPEAKERS OUT
SURROUND SUBWOOFER SURROUND
Red
VIDEO
FM ANT
OUT
DIGITAL FA NET
WIRELESS HDMI OUT
AUDIO IN (Only For Service)
OPTICAL
AUX COMPONENT
IN 2 OUT
WIRELESS
TX card
17
English