115 - 230V Ac Selector Switch; Rack Mounting - Parasound Zhd Owner's Manual

AC VOLTAGE, INSTALLATION, AND RACK MOUNTING
115v - 230v AC Voltage Selector Switch
This switch is found on the chassis bottom. The 115V position of this switch is correct for North
America; most other countries require setting it to 230V. Make sure the 115/230V switch is set
for the correct AC line (mains) voltage before you connect the Zhd's power cord and before you
install it. The unit may be seriously damaged if this switch is set incorrectly.
AC Voltage Selector Switch.
230
Shown set for 230v.

Rack Mounting

The Zhd occupies only half the width of a single rack space in a standard 19" equipment rack.
For rack mounting, you can fasten it to another Parasound Z Custom model by using the
Parasound SBS (Side-by-Side) mounting kit. You can also mount a single Zhd in the rack with
the accessory Zblank panel. The SBS includes four rack mount bolts plus four pairs of plastic
"shoulder washers." The washers are important because they insulate the Zhd front panel
chassis) from the metal equipment rack and from the four mounting bolts. Locate these washers
on both sides of the front panel before the mounting bolts are screwed into the rack rail.
Zhd SBS Zblank panel
Behind Panels
3