Samsung Refrigerator User Manual page 11

Connecting to the water supply line
1. First, shut off the main water supply line.
2. Locate the nearest cold, drinking water line.
3. Follow the Water Line Installation Instructions in
the installation kit.
CAUTION
The water line must be connected to
the cold water pipe.
If it is connected to the hot water pipe,
it may cause the purifi er to malfunction.
Close Main Close Main
Water pipe Water pipe
Close Main Close Main
Water pipe Water pipe
4. After connecting the water supply to the water
fi lter, turn your main water supply back on and
Dispense about 3L to clear and prime the water
fi lter.
Connecting the water line to the
refrigerator
1. Remove the cap from water line on the unit and
insert compression nut to the water line on the
unit after disassembling from provided water line.
2. Connect both water line from the unit and water
line in the kit
3. Tighten the compression nut onto the
compression fi tting. Be careful no gap between
two items.
4. Turn water on and check for any leakage.
Remove Remove
Loosen a Loosen a
cap cap
Water Line Water Line
from unit from unit
Water Line Water Line
from Kit from Kit
Only connect the water line to a drinkable
water source.
If you have to repair or disassemble the water line,
cut off 6.5mm of the plastic tubing to make sure you
get a snug, leak-free connection.
CAUTION
• Samsung Warranty does not cover WATER LINE
• It'll be done at customer's charge unless the retail
• Please contact Plumber or Authorized Installer for
• If Water leakage occurs due to improper
No gap No gap
1. Slip the compression nut (A) through the supplied
2. Tighten the compression nut (A) onto the 1/4"
- If you are using copper tubing, slip the
- If you are using plastic tubing (B), insert the
CAUTION
3. Tighten the compression nut (B) onto the
4. Turn water on and check for any leakage.
No gap No gap
Before being used, the leakage in these
places should be examined
INSTALLATION.
price includes installation cost.
the installation if needed.
installation, Please contact installer.
No Leak No Leak
plastic tubing (A).
compression fi tting.
compression nut (B) (not included) and ferrule
(not included) on copper tubing (not included) as
shown.
molded end(Bulb) of the plastic tubing (B) into
the compression fi tting.
Do not use without the molded end(Bulb) of
the plastic tubing (B).
compression fi tting. Do not over-tighten the
compression nut (B).
Only connect the water line to a drinkable
water source.
If you have to repair or disassemble the water
line, cut off 1/4" of the plastic tubing to make
sure you get a snug, leak-free connection.
setting up _11