Talon Tools AT33581 User Manual page 4

ASSEMBLY INSTRUCTIONS
• HANDLE ASSEMBLY
NOTE: The Handle is attached
to the shaft but has beened
turned under for ease of pack-
ing.
1. Loosen adjustment knob
(A) and rotate handle (B)
to top of shaft. Position
handle follow the arrow.
See Fig. 1
2. Tighten adjustment knob
Fig. 1
securely.
• DEBRIS SHIELD
WARNING: The debris shield must be
installed (Fig. 2) to properly dispense trim-
ming line and protect operator.
Shield fits snug on shaft. Some effort may be required.
1. Seat shield (B) onto shaft bracket (C).
2. Insert washers (D) onto bolt.
3. Insert bolt (E) and nut (F), tighten securely.
B
• INSTALLING ATTACHMENTS
NOTE: To make installing or removing attachments easi-
er, place the unit on the ground or on a work bench.
1. Turn the knob (A) counterclockwise to loosen (Fig.
3A).
2. While firmly holding the attachment (B), push it
straight into the Quick-Change coupling (C) until the
release button (D) appears in the primary hole (E)
(Fig. 3B)
3. Turn the knob (A) clockwise to tighten. (Fig. 3C)
All attachments are designed to be used in the primary
hole unless otherwise indicated in the specific attachment
operators manual. If the incorrect hole is used, it could
result in injury, or damage to the unit.
B
A
• FUEL
Use regular grade unleaded gasoline mixed with Talon
25:1 custom 2-cycle engine oil for best results. Use mixing
ratios in FUEL MIXING TABLE.
• MIXING FUEL
Add the oil to an approved fuel container followed by the
gasoline to allow incoming gasoline to mix with oil. Shake
the container to ensure thorough mix.
• FUEL MIXING TABLE
GASOLINE Talon 25:1 Ratio
Custom Lubricant
5 Liters 6.7 oz. 200ml (cc)
1 Imp. Gal. 6.1 oz. 180ml (cc)
Mixing 25 Parts Gasoline
Procedure to 1 part Lubricant
1ml = 1cc
7
AU