ASSEMBLY INSTRUCTION
STEP 1
(See Diagram 1)
A.) Pull the Sensor wire (#23) through the opening on the Computer Base (#2) and
connect the wire to the Computer (#1).
B.) Slide the Computer onto the Computer Base. Attach the Computer Base to the
top opening on the Main Frame.
C.) Thread the Lock Knob (#3) into the hole on the Main Frame. Turn the Knob
clockwise to raise up the pedals.
D.) Adjust the tension of the pedals by turning the dials on the shocks. Make sure
both pedals have the same tension.
4
DIAGRAM 1