Assembly Instructions - Impex MARCY MS-69 Owner's Manual

ASSEMBLY INSTRUCTION
Tools required for assembly of the Mini Stepper: One Adjustable Wrench, Allen
Wrench, and one Philips Screw Driver.
STEP-1 (See Diagram 1)
A.) Turn the two Rear Base End Caps (#13) 180 so the flat part points down.
B.) Attach the left Hydraulic Cylinder (#7) to the bracket under the Left Pedal
Support (#3). Secure it with one M8 x 1 5/8" Allen Bolt (#16), two Ø 5/8"
Washers (#20), and one M8 Aircraft Nut (#23). Repeat the same procedure to
install the right Hydraulic Cylinder to the Right Pedal Support (#2).
C.) Attach the two Pedals (#12) onto Left and Right Pedal Support (#2 & #3).
Secure each Pedal with two M4.8 x 5/8" Self-tapping Screws (#18).
D.) Install one AAA battery to the Computer (#14). Connect the sensor wire from
the Main Frame (#1) to the Computer. Attach the Computer to the Main Frame.
0
5
DIAGRAM 1