The Hand-Held Remote - Niles ZR-4 SERIES 2 Installation Manual

BASS AdJUSTMENT
A source should be playing through the speakers in the zone. To
set the bass adjustment at a zone keypad press and hold the
and bottom right key simultaneously for three seconds. The
Master
bottom right key LED will be blinking.
Master
Press the key to increase the bass or the
volume +
decrease the bass.
To reset the bass to its default flat setting, press-and-hold the
– keys simultaneously for two seconds.
and
volume + volume
To save your changes and exit configuration mode, simultaneously
press and hold the and bottom right
Mute
seconds. The keypad will return to its previous state.
Repeat these steps for the remaining zone keypads.
TREBLE AdJUSTMENT
A source should be playing through the speakers in the zone. To set
the treble adjustment simultaneously press-and-hold the
bottom left key on a zone's keypad for three seconds. The
Master
bottom left key LED will be blinking.
Master
Press the to increase the treble or the
volume + key
decrease the treble.
To reset the treble to its default flat setting, press-and-hold the
–
and
volume + volume keys
To save your changes and exit configuration mode, simultaneously
press and hold the and bottom left
Mute
seconds. The keypad will return to its previous state.
Repeat these steps for the remaining zone keypads.

ThE hANd-hELd REMOTE

INSTALLING BATTERIES
Your Niles
R-6l hand-held learning Remote control
batteries (included).
BATTERy USE ANd SAFETy
• Use only fresh batteries of the required size and
recommended type
• Do not mix old and new batteries, different types
of batteries (standard, alkaline, or rechargeable), or
rechargeable batteries of different capacities
• If you do not plan to use the remote for an extended
period, remove the batteries. They can leak chemicals
that can destroy electronic parts
22
volume
keys for three
Master
Mute
volume
simultaneously for two seconds.
key for three
Master
requires 2 "AA"
IR SENSOR ON/OFF
By factory default the IR sensor is set to the
Mute
To turn the keypad's internal IR sensor on or off, simultaneously
press-and-hold the
seconds. The upper right
– key to
Press the
volume + key
To save your changes and exit configuration mode, simultaneously
press-and-hold the
seconds. The keypad will return to its previous state.
Repeat these steps for the remaining zone keypads.
vARIABLE LOUdNESS ON/OFF
By factory default variable loudness is set to the Off position.
To turn the zone's variable loudness on or off, simultaneously press-
and-hold the
Mute
upper left
Master key
and
Press the
volume + key
To save your changes and exit configuration mode, simultaneously
– press-and-hold the
to
key
seconds. The keypad will return to its previous state.
Repeat these steps for the remaining zone keypads.
waRnIng: DISpoSe of olD BaTTeRIeS pRoMpTly anD pRopeRly. Do
noT BuRn oR BuRy TheM.
TO inSTaLL BaTTeRieS:
1. Open the battery compartment cover (located on the
back of the remote).
2. Place the "AA" batteries in the compartment and match
the and – polarity symbols inside.
+
3. Replace the cover.
noTe: when The BaTTeRy volTage IS low, The SouRce Key leD wIll
BlInK 5 TIMeS afTeR a KeypReSS.
nileS audio corPoration – 1-800-BuY-hifi – 305-238-4373
position.
on
and upper right
Mute Master key
key LED will be blinking.
Master
to turn it on. Press the
volume
and upper right
Mute Master key
and upper left for three seconds. The
Master key
LED will be blinking.
to turn it on. Press the
volume – key
and upper left
Mute Master key
for three
–
to turn it off.
key
for three
to turn it off.
for three