Configuring The Zone - Niles ZR-4 SERIES 2 Installation Manual

CONFIGURING ThE ZONE

Press the + button to confirm the erase procedure. The display will
show [MaSTeR DefaulT ReSToReD].
M A S T E R
D E F A U L T R E S T O R E D
Press the – button (at either screen) to exit and move to the next step
without erasing any information.
To continue to the first configuration step, MaSTeR/SLaVe, press the
Set button.
To save the settings and exit configuration mode, simultaneously
hold down the Band and Set buttons. After the ZR-4 saves the
information, [ReleaSe BuTTonS To conTInue] appears on the
display. The ZR-4 will return to the normal operating mode.
SETTING Up ThE AM/FM TUNER
The built-in tuner can store up to twenty presets in any combination
of AM or FM stations. In Master/Slave configurations, each
tuner could store different presets providing a system total of 40.
However, each keypad can only operate the tuner in the ZR-4
MultiZone Receiver to which it is connected, so each zone has
access to 20 presets.
To SToRe pReSeTS In The TuneR:
Press the Band button to choose between aM or fM. The display will
show aM or fM to indicate the current band along with the current
station [aM560].
A M 5 6 0
Press the + or – button to tune to the desired station. Each press and
release will increment the tuner frequency up or down. A press-and-
hold initiates the seek function. The tuner will move up or down to
the next station with a clear signal. Continuing to hold the button will
cause the tuner to pause at any station for 3 seconds before seeking
the next station. Releasing the button will stop the seek function and
the tuner will remain on the last tuned station.
F M 9 3 . 1
nileS audio corPoration – 1-800-BuY-hifi – 305-238-4373
Once the desired station is displayed, press-and-hold the Set button
(2 seconds). The display will change to [pReSeT xx Save] where XX
is the next available open preset.
F M 9 3 . 1
P R E S E T 0 1 S A V E
Press the + or – buttons until the desired preset location is displayed
(01 – 20). It will always stop at the first available blank preset. Press
the + or – button to overwrite any previously saved preset.
F M 9 3 . 1
P R E S E T 0 1
noTe: If The SelecTeD pReSeT alReaDy haS a STaTIon aSSIgneD, IT
wIll Be oveRwRITTen anD The new STaTIon wIll now Be SToReD In
ThaT pReSeT locaTIon.
Press-and-hold the Set button for 2 seconds. This will save the
station in the displayed preset location. The ZR-4 MultiZone Receiver
will return to normal operation. The display will show the station and
the preset.
F M 9 4 . 9
P R E S E T 2
Repeat these steps until all desired stations are preset or the available
twenty presets are filled.
Presets may be erased one of two ways: by storing a new preset in
the location; or by entering configuration mode and electing to erase
all presets (see "
erasing Tuner Preset information
").
(continued on next page)
21