Utilitech UT-6028-BZ Owner's Manual page 4

3. Adjust RANGE Control. To increase sensitivity, turn the RANGE
control toward MAX. To decrease sensitivity, turn the RANGE
control toward MIN. Note: If the RANGE is set too high, false
triggering may result in some environments.
Note: When using test mode to check operation in the day time:
A. Set the DETECT control switch to DAY/NIGHT and
B. Set the ON-TIME control to TEST.
4. Set ON-TIME Control. Determine the amount of time you want
the connected device to stay on after motion is detected (1 or
5 minutes). Slide the ON-TIME control to the corresponding
setting.
IMPORTANT: Avoid Aiming Control At:
• Objects that change temperature rapidly, such as heating vents,
fans, and air conditioners. These air sources could cause false
triggering.
• Areas where pets or traffic may trigger the control.
• Nearby large, light colored objects reflecting light may trigger the
shut-off feature. Do not point other lights at the sensor.
Outdoor Motion Sensor
ON-TIME Control
LED Indicator
Motion Sensor Controls
ON-TIME RANGE
(MINUTES) MAX MIN
5 1 TEST
Range Control
8 ft.
(2.4 m)
Maximum Range
Motion Sensor Coverage Area
Motion
Sensor
Least Sensitive
The detector is most sensitive to motion across its field of view.
Motion Sensor Sensitivity
Aim Sensor down
for Short Coverage
Adjusting Motion Sensor Coverage
4
70 ft.
(21 m)
Maximum
Coverage Angle
Motion
Sensor
Most Sensitive
Aim Sensor Higher
for Long Coverage
598-1296-02
180°