Installing Batteries - Utilitech UT-6028-BZ Owner's Manual

Estimated Installation Time: 30 minutes
Items needed for installation (not included):
• Phillips and flathead screwdrivers
• Pliers • Wire strippers/cutters
• Safety glasses • Light bulbs
• Silicon caulk • Black tape
outdooR WIRELESS MotIoN SENSoR
Features:
• No wiring required.
• Up to 70 feet sensing range, 180° Cover-
age.
• Adjustable sensitivity.
• Day/Night or Night only operation.
• Test mode.
Outdoor Wireless
• Uses 2 AA batteries.
Motion Sensor
• Wall or eave mount.
• Controls receivers up to 100 feet away.
Select Night or 24 Hour Mode
These sensors are able to detect motion day and night or night
only. To set the detection mode, remove battery compartment
cover by sliding the cover down. Remove batteries if necessary.
Slide the DETECT switch to either the DAY/NIGHT or NIGHT
ONLY position. Replace battery compartment cover by reversing
the above instructions.

Installing Batteries

• Before mounting outdoor motion sensor, remove battery compart-
ment cover by sliding the cover down.
• For indoor motion sensor, install batteries after sensor is in-
stalled.
Install 2 AA batteries according to polarity markings inside the
battery compartment. Replace battery compartment cover by
reversing the above instructions.
1 2 3 4
CODES
Outdoor Motion Sensor
(Rear View)
Battery Compartment
598-1296-02
Detect
DAY NIGHT
Control
NIGHT ONLY
DETECT
Installing outdoor Motion Sensor
1. Install sensor mounting bracket where motion detection is desired.
Attach sensor mounting bracket to a sturdy object (i.e. tree, post,
house, etc.) using two screws provided. Make sure unit has an
unobstructed view. Note: Attach mounting bracket vertically if
connecting to a curved surface such as a post.
2. Install motion sensor to mounting bracket. Using a Philips-head
screwdriver, loosen the clamp screw on the mounting bracket.
Insert swivel ball mount on sensor into mounting bracket socket
(Note: You should hear a snap). Aim sensor toward area where
detection is desired. Tighten clamp screw.
IMPORTANT: The sensor must be mounted with the bottom cover
facing down in order to maintain water tightness.
Mounting
Bracket Socket
Clamp
Screw
Swivel Ball Mount
Sensor
Installing Motion Sensor
Check operation and Adjustment
Note: When first turned on or when switching modes wait 30
seconds.
Locate the RANGE control and ON-TIME control on the motion
sensor:
• Indoor Motion Sensor - The RANGE control and ON-TIME
control are located inside the battery compartment on the front
of the sensor. To set the RANGE or ON-TIME control, remove
battery compartment cover by sliding the cover down.
• outdoor Motion Sensor - The RANGE control and ON-TIME control
are located on the bottom of the sensor. Using your fingernails or
a small, flat-head screwdriver, gently pry the cover until it opens.
1. Check Operation. Set the ON-TIME control to TEST mode. Walk in
front of sensor unit. The LED indicator light should flash when motion
is detected (see illustration, page 8, for location of LED light).
2. Adjust Sensor. Turn the RANGE control to the mid position
and ON-TIME control to the TEST position. Walk through
coverage area noting where you are when the LED begins to
flash. Loosen the clamp screw and move the sensor to change
the coverage area. Tighten clamp screw when finished. Do not
overtighten clamp screw.
3
Mounting Bracket
Mounting Screw
Nut