Samsung AWT17XSHDA Owner's Instructions Manual page 30

Installation
Installation of the Drain Tube
Fix the drain tube as shown in the figure.
Rear
Rubber cap
Gasket
Drain Tube
Screws(2EA)
Installation of the Drain Pan
The procedure for installing the drain pan should be determined by the
condition of the installing area.
In the case of an area where the drain pan can not be directly
installed on the rear side of the unit after installing the air conditioner .
Example: High storage
1 Open the front grill ; refer to page 26.
2 Remove the front panel.
2-1 Press both sides of the cabinet in the direction of the arrow
2-2 Pull the lower part of the front panel slightly forward.
2-1
2-1
2-3 Lift the front panel upward.
Front panel
3 Remove two screws on the lower , right and left sides of the unit.
4 Remove the chassis from the cabinet.
5 Remove the rubber cap inserted into the basepan.
Drain Pan
6 Fix the drain pan as shown in the figure, and then connect the drain hose.
Rear
(You can use any commercially-available drain hose.)
7 Install the cabinet at the specified area after installing the drain pan,
and then re-assemble it in the original condition.
Screw
Rubber cap
Drain Hose
Bottom-Side View with
Drain Pan and Hose in Place
In the case of an area where the drain pan can be directly installed
on the rear side of the unit after installing the air conditioner .
1 Follow steps 5 and 6 only
21 30
E- E-
as shown in the figure.
(below three inches)
Applying excessive force to remove the front panel may cause
damage to the tab ; be sure not to use excessive force.
Tighten the supplied screw on the lower part of front panel to secure
the front panel.