Table of Contents
Advertisement
1. Plug into
USB Port
3. Click
(ID button)
4. Click the receiver's connect button once (located on the back of the receiver)
within 5 seconds after clicking the connect button on the mouse. The LED will
start blinking, when the connection is established.
5. Move the mouse around to test if it was successful.
6. If the synchronization is not successful for some reason please
a. Remove the batteries and unplug the receivers
b.
Wait for 20 sec then to try the step 1 to 4 again.
Note: * During normal use, please make sure that the mouse is no more than 3 ft
away from the receiver in order to have reliable connection.
** The LED on the receiver will light up or blink while the mouse is being
used.
Restorable Optical Wireless Mouse
Page 5 of 11
2. Click
(ID button)
2.2 Edition
Advertisement
Table of Contents
