Chevin S600 User Manual

S600/s800 professional power amplifier

Advertisement

Quick Links

USER MANUAL

S600/S800
PROFESSIONAL POWER AMPLIFIER
Chevin Research, Kreuzbichlstraße 29 A-6112 Wattens, Austria
Tel/Fax: +43 (0)5224 51398
chevin.martin @aon.at
,
sales@chevin-research.com
www.chevin-research.com
1
Contents
Important safety instructions ..................
Introduction ............................................
Front Panel ............................................
Rear Panel .............................................
Clip-Limiter ............................................
Subsonic Filter .......................................
Stereo Mode ..........................................
Caution: To reduce the risk of electric shock do not remove the cover.
No user-servicable parts inside. Refer servicing to qualified service personnel.
Warning: To prevent fire or electric shock do not expose this equipment to rain or moisture.
The exclamation point within an equilateral triangle is intended to alert the user to the
presence of important operating and servicing instructions in the literature accompanying the
product.
The lightning flash with arrowhead symbol within an equilateral triangle is intended
to alert the user to the presence of uninsulted "dangerous voltage" within the product's enclosure
that may be of sufficient magnitude to constitute a risk of electric shock.
WARNING - When using electric products basic precautions should always be followed,
including the following:
-
Read all these instructions before using the product.
Do not use the product near water e.g. near swimming pool, kitchen sink, bathtub, or in
-
a wet basement, etc.
This product, either alone or in combination with other sound equipments, is capable of
-
producing sound levels that can cause permanent hearing loss. Do not operate the
product for a long time at high volume level.
The product should be located away from heat sources such as direct sunlight or other
-
sources of heat.
The product should be connected to a power supply only of the type marked on the rear
-
panel of the product.
-
The power supply cord of the product should be unplugged from the mains socket when
left unused.
2
3
Parallel Input Mode ................................
3
Bridge Mono Mode .................................
4
Installation and Dimensions ...................
4
Connectors and Connections .................
5
Operation ...............................................
5
Technical Specifications ........................
2
6
7
8
9
10
12

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the S600 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Chevin S600

  • Page 1: User Manual

    The product should be connected to a power supply only of the type marked on the rear panel of the product. Chevin Research, Kreuzbichlstraße 29 A-6112 Wattens, Austria The power supply cord of the product should be unplugged from the mains socket when Tel/Fax: +43 (0)5224 51398 left unused.
  • Page 2: Rear Panel

    Avoid allowing any objects to enter inside the product or spilling any liquid into it. Rear Panel The product should not be used when: The power supply cord or plug has been damaged Objects have fallen or liquid has been spilled into the product The product has been exposed to rain The product does not appear to operate normally or exhibits a marked change in performance...
  • Page 3: Subsonic Filter

    Subsonic Filter The subsonic (low-frequency) filter rolls off signals below either 40Hz or 80Hz. This means more power is available for the speakers’ rated frequency range. The filter settings for each channel are controlled individually through the DIP switchs. If the subsonic filter is off, there is 5Hz rolloff available to protect against DC or sub-audio inputs. SEND: The same signal that is present at the INPUT connector is at the SEND connector to link to other equipment.
  • Page 4: Parallel Input Mode

    You can use parallel input mode to drive two speakers with one input signal while keeping Installation and Dimensions independent control of both channel-gains filtering and limiting. The amplifier can be used in rack mounting or single. Note: If you use a balanced signal, use only balanced cables. Even one unbalaced cable will Use 4 screws and washers when mounting the amplifier to the front rack rails.
  • Page 5: Bridge Mono Mode

    Operating Voltage Connectores and Connections Before connecting the amplifier to the mains socket always make sure that: The electric system and mains socket have an adequate grounding – compatible with Inputs the safety regulations for your country (if you are uncertain consult specialised personnel);...
  • Page 6: Technical Specifications

    This manual is intended for informational purposes only. All details included herein are subject to change without notice. Power 220 – 240V ~ 50 – 60 Hz Chevin Research shall not be held responible for any damages, direct or indirect, arising from or relating to the use of this manual. Max power consumption (230V ~) 2200VA / 2400VA ©...

This manual is also suitable for:

S800

Table of Contents