Advertisement
13. ADJUSTING FABRIC FEEDERS
By using the push buttons you can adjust the fabric feeders for sewing diftercrt
types of materials and other special sewing, such as emroidering or darning.
1. For ordinary sewing, press "tP" button all the way down, ([his raises the
fabric feeders to the up position)
2. For sewing very light fabrics, press 'DOWN" button half way down so that
the center line of the "UP" button appears on the plate.
3. To lower the fabric feeders below the surface of the needle plate, piess the
"DOWN" button all the way down. The fabric feeders are now in the down
position, and you will be able to move your material freely in any direction,
such as when you desire to embroider or darn. When embroidering and darning,
remove the presser foot and use an embroidery hoop.
"UP" Position
Normal Fabrics
DOWN
UP
:'
;::
S S
DOWN
UP
"DOWN" Position
Embroidering & Darning
Fig. 24
DOWN
Fig. 23
14. ADJUSTING PRESSURE OF THE PRESSER FOOT
1. To release the pressure on the material, press down on the curled ring (A). (This
will allow the built-in darner (B) to raise, thus releasing the pressure on the
material.)
2. To increase the pressure on the material, press down on the built-in darner (B).
NOTE The built-in darner will stop at any position you desire.
3. For normal sewing, push built-in darner all the way down.
4. For darning and embroidering, release the built-in darner.
CAUTION
Even though the presser foot is removed, make sure the presser
bar lifter is in the down position.
5. Adjust the built-in darner to the proper position according to the thickness of
the material you are using.
9
Advertisement
