Setup; Battery Installation; Battery Saver; Code Saver - GE 20622 Instruction Manual

Setup

Battery Installation

1. On the back of the remote, push down on the tab and lift the
cover off.
2. Match the batteries to the + and - marks inside the battery
case, then insert 2 AAA Alkaline batteries.
3. Press the battery cover back into place.

Battery Saver

Your remote automatically turns off if the buttons are depressed
more than 30 seconds. This will save your batteries should your
remote get stuck in a place where the buttons remain depressed
(e.g., between the sofa cushions).

Code Saver

You will have up to 10 minutes to change the batteries in your
remote without losing codes you have programmed. However, do
not press any buttons until batteries are installed in the remote. If
buttons are pressed without batteries in the remote, all codes will
be lost.

Code Setup

The SETUP button is used to setup the remote. You can either setup
the remote using the code tables (on separate sheet), or you can
search through the library of codes until you find a code that works
for your product. Please refer to " Code Search" on page 7 for
more information on using the code search feature to learn how to
search through the library of codes for your products.
NOTE: You can store any kind of code under any mode (except TV).
I.E. you can store a DVR code under the CBL/SAT button, or a Cable
code under the DVD/DVR button, etc. However, you can only store
TV codes under the TV button.
3