Vented Installation - Heartland Appliances 4200 Installation And Operating Instructions Manual

Vented Installation, Tools, Material, and Dimensions
Tools required to install vented hood:
Materials Required:
- 3 1/4" x 10" (82.55 mm x 254 mm) metal duct—enough to go through wall or attic to outside. Elbows as required.
- Roof cap or wall venthood
- Caulking to seal around duct
- #6 x 1/2" (82.55 mm x 254 mm) sheet metal screws
The above are standard parts and are available at any hardware store or heating contractor.
NOTE : A 3 1/4" x 10" (82.55mm x 254mm) exhaust adaptor is included with the exhaust hood.
Venting Safety Guidelines
Installation must be done in
accordance with all local and
national codes.
Use only materials which
conform to local codes in
effect. Be sure power is
disconnected before doing
any electrical work. All duct
work must be metal.
Do not use plastic duct. The
range hood should never
be exhausted into a wall
cavity or an attic where an
accumulation of grease
could become a fire
hazard.
When the installation is
completed, turn on the fan
and make sure that there are
no obstructions in the duct.
- Pliers
- Measuring tape
- 1/2" (13 mm) Drill bit
1 4.0 "
355 m m
74 9 m m
28"
711 m m
14 7 /8 "
37 8 m m
5 6 "
1 42 2 m m
36 1 /8 "
91 7 m m
34"
864 mm
3"
76 mm
7 56 m m
- Hammer
- Electric drill
- 3/32" (3 mm) Drill bit
- Sabre saw OR Keyhole saw
56 "
1 422 m m
36 1/8 "
91 7 m m
76 2 m m
R ange Ho od O u tle t
3 1/4"x 10"
83 mm x 254 m m
6 6 1 /4 "
1 68 2 m m
6 2 3 /8 "
1 58 5 m m
29 3 /4 "
30" Model
5
- Slot screwdriver
R an ge H oo d O utlet
3 1/4" x 1 0"
8 3 m m x 25 4 m m
4 3/4 "
12 1 m m
G as Inlet-1/2" N PT
E x h a us t H o o d In
(f em al e rece p tac le )
30 "
39 3 /4 "
10 10 m m
47 1/2 "
120 7 m m
48" model
14 .0 "
35 5 m m
2 9 1 /2"
7 8 7 m m
7 11 m m
20 "
50 8 m m
66 1/ 4"
16 82 m m
Ov en E xha ust
P o w e r C o rd
2 8 "