X2 Digital Wireless Systems XDR95 User Manual page 9

TRANSMITTER CONTROLS
Power Button
Press once to turn the unit on. Press and hold to turn the unit off. Hold channel button and power unit on to set it for XDS
compatible mode. The unit will remain in this mode until it is powered up again in the same way, thus returning it to XDR mode.
Power up LED sequence for
will light for channel, a red LED for battery. Audio level LEDs are blue indicating that the unit is in XDR mode.
Power up LED sequence for
will light for channel, a red LED for battery. Audio level LEDs are red indicating that the unit is in XDS mode (allowing for
operational compatibility with original XDS95 'stomp-box' receivers). NOTE: this mode does not provide battery telemetry.
Channel Select Button
Press the CH SEL button to select the next channel. Button sequence will wrap around. For example, once CH5 is selected
you must press the CH SEL button one time to reach CH1. Receiver must be set to the same channel as the corresponding
transmitter in order to operate correctly.
LED Display (factory XDR mode)
A blue LED will light indicating the currently selected channel of operation and a red LED indicates remaining battery life in one
hour increments. When idle, these LEDs toggle continuously. During performance, blue LEDs indicate input level. There is no
need for a CLIP indicator as the system has greater than 118 dB dynamic range and can accommodate input/output signals up
to ~6V peak-to-peak.
LED Display (XDS mode)
The XDS mode allows users the option to mix and match components between the XDR95 system and the XDS95 'stomp-box'
styled system. A blue LED will light indicating the currently selected channel of operation and a red LED indicates remaining
battery life in one hour increments. When idle, these LEDs toggle continuously. During performance, red LEDs indicate input
level. Once again, there is no need for a CLIP indicator as the system has greater than 118 dB dynamic range and can accom-
modate input/output signals up to ~6V peak-to-peak.
LED Display -
A blue LED indicates channel,
red LED indicates battery life.
When idle, these LEDs toggle.
During performance, blue LEDs
indicate input level.
Power button
XDR mode (factory) : all blue LEDs light up and hold while red LEDs sweep through. A blue LED
XDS mode : all blue LEDs light up then red and blue LEDs sweep through alternately. A blue LED
FIGURE 10
7
Channel Select button