Table of Contents
Advertisement
SYSTEM INSTALLATION
The system can be installed either on a surface (Fig. 2) or recessed (Fig. 4).
NOTE: Before surface mounted installation, please remove the plastic
back cover (Fig. 1) before fitting panel into the stainless steel panel housing.
NOTE: Before recessed mounted installation, please KEEP the plastic
back cover (Fig. 3) attached to the panel.
WIRING DIAGRAM
ADVISORY:
Light gauge is recommended (22ga stranded) for
wiring unit's open command.
Seal unit with silicone sealant paying careful
attention to metal housing. Do not use silicon
sealant on plastic housing or cover.
Be very careful with antenna when installing
cover.
Tape antenna connections with electrical tape.
Do not pinch antenna cable when installing
cover.
Do not use near sprinkler system.
Disconnect power when servicing equipment.
If the system is constantly emitting a tone during
installation, it's a sign that there is poor reception in
the area. To remedy the situation move the cellular
antenna until the module stops emitting a tone.
8
4 Band GSM
(900/1800/850/1900MHZ)
Wireless Module MC55i
Terminal
Made by Cinterion
Made in Germany
Advertisement
Table of Contents
