Led Indicators; Adding Admins & Users; Adding Admins; Upgrading An Admin To Power Admin - Sentry GSM‐DE3100 User Manual

LED INDICATORS
LED Status Indicator
Red Flashing = Standby
Red Solid = Using
ADDING ADMINS & USERS
ADDING ADMINS
The system has the ability to store one (1) Power Admin and three (3) Admins, where the Power Admin is an upgraded status for SMS programming
and confirmation.
Note: An Admin must be added into the system before adding users or changing settings. One of the Admins must be used to be upgraded to a
Power Admin. When registering a user for dialing in, the owner has to add the country code "1" before the phone number.
The default Passcode is 1234.
1) Use your cell phone to dial into the system by entering the phone number of the SIM Card installed in the system. You will hear a long
tone when the door system answers the call.
2) To add first Admin, enter:
To add a second Admin, enter:
To add a third Admin, enter:
Note: Successful key code acceptance is followed by one long tone. Unsuccessful key code is followed by three short tones. There is no
option to delete an Admin, but an Admin can be overwritten.
Example 1: An Admin wants to register Admin 11 into the system. His phone number is 999‐555‐1234.
Step 1 Step 2
Enter Program Admin Passcode
Mode
12 1234
UPGRADING AN ADMIN TO POWER ADMIN
To upgrade an Admin to a Power Admin, enter Admin Program Mode ( 12 ) then use function code 74.
To upgrade Admin to Power Admin
for SMS programmability, enter:
To remove Power Admin status
for SMS programmability, enter:
Example 2: An Admin wants to upgrade Admin 11 to Power Admin.
Step 1 Step 2
Enter Program Admin Passcode
Mode
12 1234
ADDING USERS
An Admin has the responsibility of adding users into the system.
To add User 1, enter:
To add User 2, enter:
To add User 9, enter:
LED Network Indicator
Red flashes once per 3 seconds = Ready
Red flashes once per second = Searching
Red Solid = Busy
12 1234 # 11 1phonenumber #
12 1234 # 12 1phonenumber #
12 1234 # 13 1phonenumber #
Step 3
End Passcode
(11, 12, 13)
#
12 1234 # 74 1phonenumber #
12 1234 # 74 1phonenumber #
Step 3
End Passcode Function Code
#
12 1234 # 72 1 1phonenumber #
12 1234 # 72 2 1phonenumber #
12 1234 # 72 9 1phonenumber #
Step 4
Admin Country Code + Telephone Number
(11 digits ‐‐ including country code 1 &
phone number with area code)
11 1 999 555 1234
Step 4
Country Code + Telephone Number
(11 digits ‐‐ including country code 1 &
phone number with area code)
74 1 999 555 1234
Input 1‐100 user IDs; 3 digit place holders not necessary
10
LED Power Indicator
Red Solid = Power On
Red Off = Power Off
Step 5
Note: SMS texts are limited to
140 characters per message
when using SMS programming.
Step 5
Step 6
End
#
Step 6
End
#