Agilent Technologies Agilent E5810A User Manual page 68

Installing the E5810
Installing and Configuring the Agilent IO Libraries Suite
named is configured when you start or refresh Connection
TCPIP0
Expert. To change timeouts and protocol properties for your remote
interface, you must change the properties of this TCPIP interface.
5 If your E5810 is on a different subnet from your client PC , type the
hostname or IP address of the E5810 in the
dialog box. Change the value in the
if necessary, to match the
E5810
Welcome
If your E5810 is on the same subnet as your client PC , click
. Then, in the
Interfaces...
, select your E5810 from the list, and click
Find Now
Remote GPIB interface
6 In the
Remote GPIB interface
connectivity to your E5810. If the test is successful, you will see the
message
The interface was successfully opened
If you leave the check box labeled
checked, then when you click
to this interface
will search for GPIB instruments connected to your E5810 and will send
a (identification) query to each instrument found. You will then
*IDN?
see the new remote GPIB interface and any attached GPIB instruments
in the Connection Expert's explorer view.
68
Interface name on remote host:
GPIB SICL Interface Name
page.
Find Remote GPIB Interfaces
dialog box.
dialog box, click
Auto-discover instruments connected
Remote GPIB interface
displayed on the
Find
dialog, click
to return to the
OK
to check
Test connection
.
, Connection Expert
OK
Chapter 2
field,