Agilent Technologies Agilent E5810A User Manual page 66

Installing Agilent
IO Libraries Suite
Installing the E5810
Installing and Configuring the Agilent IO Libraries Suite
If your version of the Agilent IO Libraries is at least L.01.01, but less
than the version on your Automation-Ready CD , you may want to
install the newer version to take advantage of new features and
greater ease of use of the more recent Agilent IO Libraries Suite.
Note that Agilent IO Libraries Suite 14.0 was the revision
immediately following Agilent IO Libraries M.01.01, so you should
consider revision "14.0" to be a greater version number than "L" or
"M". Configuration instructions in this manual refer to Agilent
IO Libraries Suite 14.0.
To install the Agilent IO Libraries Suite software,
1 First, disconnect any USB instruments, USB/GPIB converters, and
FireWire-VXI interfaces that are connected to your PC.
2 Insert the Automation-Ready CD into your CD-ROM drive. Wait a few
seconds for the
NOTE
If you do not have the Automation-Ready CD, go to
www.agilent.com/find/iolib to download the Agilent IO Libraries Suite.
3 If the window does not appear automatically,
Click
Start | Run...
Type <drive>:autorun\auto.exe , where <drive> is your
CD drive letter.
4 When the
Agilent IO Libraries Suite 14.0
directions in this window to install the Agilent IO Libraries Suite. (See
the Agilent IO Libraries Getting Started Guide on your Automation-
Ready CD for a full description of installation options and installation
troubleshooting information.)
5 Go to "Configuring a Remote GPIB Interface" on page 67 to configure
GPIB instruments connected to your E5810.
Go to "Configuring a Remote Serial Interface" on page 69 if an RS-232
instrument is connected to your E5810.
66
Agilent IO Libraries Suite 14.0
and/or
window to appear.
window appears, follow the
Chapter 2