Advertisement
Quick Links
Assembly Instructions for Model: AFV48
Thank you for choosing the Sanus AFV48. If you do not
understand these directions, or have any doubts about
the safety of the installation, please contact Sanus at
800.359.5520 or www.sanus.com. Check carefully to make
sure that there are no missing or defective parts. Our
customer service representatives can quickly assist you
with installation questions and missing or damaged parts.
Replacement parts for products purchased through authorized
dealers will be shipped directly to you. Never use defective
parts. Improper installation may cause damage or serious
injury. Do not use this product for any purpose that is not
explicitly specifi ed by Sanus. Sanus can not be liable for
damage or injury caused by incorrect assembly, or incorrect
use. Please contact Sanus before returning products to the
point of purchase.
Supplied Parts and Hardware
Shelf Connector - A
Qty. 10
3" Pillar - E
Qty. 6
Front Brace - J
Sanus 6436 City West Parkway, Eden Prairie, MN 55344 03.09.12 (6901-100073 <01>)
Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com
1/4-20
Top Bolt - B
Qty. 6
7" Pillar - F
Top Shelf - H
Qty. 1
Qty. 1
Spacer - C
Qty. 2
Qty. 4
Foot - K
Qty. 6
DO NOT EXCEED
200 lbs
90.9 kg
WEIGHT LIMITS!
200 lbs
90.9 kg
200 lbs
90.9 kg
Grommet - D
9" Pillar - G
Qty. 6
Bottom & Middle Shelf - I
Qty. 2
Allen Key - L
Qty. 1
Qty. 4
Advertisement
Related Manuals for Sanus AFV48B
Summary of Contents for Sanus AFV48B
- Page 1 Assembly Instructions for Model: AFV48 Thank you for choosing the Sanus AFV48. If you do not understand these directions, or have any doubts about DO NOT EXCEED 200 lbs 90.9 kg WEIGHT LIMITS! the safety of the installation, please contact Sanus at 800.359.5520 or www.sanus.com.
- Page 2 Step 1: Foot Assembly Diagram 1 Thread a Foot (K) into each 3” Pillar (E). Thread a Shelf Connector (A) into the other end of the 3” Pillar (E) until tight. Repeat this process for each remaining 3” Pillar. Step 2: Add Bottom Shelf Insert each Foot Assembly from Step 1 through the Bottom Shelf (I) as shown in Diagram 2.
- Page 3 Step 4: Add Middle Shelf Place the Middle Shelf (I) on the 9” Pillars (G). A Shelf Connector (A) should be protruding above the Middle Shelf at each corner. Place two Top Bolts (B) through the Middle Shelf (I) and thread them into both middle 9” Pillars (G) as shown in Diagram 4. Using the Allen Key (L), tighten both Top Bolts (B).
- Page 4 Step 6: Add Top Shelf Place the Front Brace (J) on the two front 7” Pillars (F) as shown in Diagram 6 and Detail A. Place the Top Shelf (H) (with its curved edge towards the front) on the Front Brace (J), and 7” Pillars (F) as shown in Diagram 6.
Need help?
Do you have a question about the AFV48B and is the answer not in the manual?
Questions and answers