Van Mechelen 1000 SERIES User Manual page 23

ESC R n (1BH,52H,n)
ESC d n (1B,64H,n)
ESC v (1BH,76H)
ESC { n (1BH,7BH,n)
ESC C n (1BH,43H,n)
Document No : DS8078
Selects an international character set from the following table
determined by the value of n. The default value is the character
set programmed in the printer.
n Country
0 U.S.A.
1 France
2 Germany
3 U.K.
4 Denmark 1
5 Sweden
6 Italy
7 Spain
8 Japan
9 Norway
10 Denmark 11
Prints the data in the print buffer and performs n line feeds.
Status request. The current printer status is transmitted to the
host computer on receipt of this command. It takes the form of
a single byte which is fixed at 0 (to indicate paper in) for the
1000 printer. The byte is sent regardless of the CTS
handshaking signal.
Inverted print command. When n = 1 then print is inverted and
text will be printed from right to left. For normal print n = 0.
The default mode is set by the programmed parameters in the
printer.
Set form length. When used in conjunction with the form feed
command (0CH), the printer will feed n lines. Note that if n =
0 then there will be no line feeds. The default value is n = 0.
Issue : J Page 23