Download Print this page

Versalab M3 User Manual

Table of Contents

Download this manual

M3 Grinder User's Manual

drag the belt around the pulley. In some cases it might be useful to remove the "pulley

guard" between the two pulleys.

rev.8

Unpacking & Installation

Included with the grinder is a

power cord and a bag of hex

wrenches. Also a dowel pin for

holding the shaft when

changing burrs.

Drive belt. The Grinder ships with

the belt installed. If you should

need to reinstall it, or replace it,

place the drive belt into the groove

of the small pulley on top of the

grinder and stretch it around the

large pulley. This will take some

effort as the belt has plenty of

tension. It will simplify the process

of getting the belt around the large

pulley if you begin by getting the

belt around one side of the large

pulley and then start to rotate the

large pulley in a manner so as to

drag this around the front. This will

Table of Contents

Need help?

Do you have a question about the M3 and is the answer not in the manual?

Page 1 M3 Grinder User's Manual rev.8 Unpacking & Installation Included with the grinder is a power cord and a bag of hex wrenches. Also a dowel pin for holding the shaft when changing burrs. Drive belt. The Grinder ships with the belt installed. If you should...
Page 2 Fuse. There is a fuse installed as shipped, and a spare included. Both are accessible in a small plastic drawer in the connector where the power cord is inserted. Further spares should be 5x20mm 2 amp slow-blow fuses. These are widely available at local stores including Radio Shack.
Page 3 Remove the static wiper. Included with the tools is a small tool similar to a hex (or Allen) wrench that fits into the retaining screw for the "static wiper". This wrench is of the "Torx" type, and instead of being a hex shape, has splines or fins, that fit into the screw head.
Page 4 This is a precision part and was checked on assembly. If the wiper has too much clearance or rubs against the bottom funnel, it has been bent out of shape. Happy Grinding! Questions? Versalab Inc. tel. 970.622.02 40 email info@versalab.com...