Connect Di-Gps® Mini 3L Series Gps Receiver To Pc - di-GPS Mini 3L Series User Manual

Connect
di-GPS® Mini 3L series GPS receiver
di-GPS® Mini 3L series GPS receiver can be connected to any PC with a USB port.
USB cable is supplied for PC connection.
di-GPS® Mini 3L series GPS receiver support Windows, Mac OSX. The Virtual COM
Port Drivers for different OS can be downloaded at the di-GPS® support page
http://www.gps.com/di-gps/support.htm.
1. Disconnect di-GPS® Mini 3L series GPS receiver from the camera.
2. Connect di-GPS® Mini 3L series GPS receiver with the USB cable.
3. Connect USB cable to USB port of PC.
4. If the di-GPS® Mini 3L series GPS receiver is properly connected, the Green
LED will start to flash, indicating the GPS receiver is searching for a signal.
di-GPS® Mini 3L series GPS receiver will automatically detect the connection of the
USB port. The power switch will be disabled when connected to PC. The power switch
only functions when connect to DSLR camera.
Glink Software is used for the data logger configuration. Please refer to Glink user guide
for log configuration and data download.
downloaded at http://www.di-gps.com/di-gps/support.htm.
Note

Do not connect USB cable to PC and 10-pin cable to camera at the same time.
di-GPS® is a registered trademark or a trademark of Dawn Technology Limited
Nikon D2HS, D2X, D2XS, D200, D3, D3S, D3X, D300, D300S, D700, D90, D3100, D5000, D5100 and D7000 are registered trademark or a trademark
of NIKON CORPORATION in the United States and/or other countries.
Fujifilm and S5 Pro are registered trademark or a trademark of FUJIFILM U.S.A., Inc. in the United States and/or other countries.
Canon and EOS are registered trademark or a trademark of Canon Inc. in the United States and/or other countries.
Products and brand names are trademarks or registered trademarks of their respective companies.
V1.2
to PC
Glink software and user guide can be
10