Installing The Software - IBM IdeaScan 2000 User Manual

Installing the software

Notes:
1. The Getting Started Guide that comes with the scanner provides basic installation
steps for experienced users. If you have problems using these steps, use the
installation instructions in this section.
2. Be sure to unlock the scanner before starting the installation steps.
To install the software:
Attention: Do not attach the scanner USB cable to the computer until the
software on-screen installation instructions prompt you to do so.
1. Start Windows 98. Be sure to close any applications that are running.
2. Insert the installation CD into your computer CD-ROM drive. The CD software
starts automatically only if autorun is enabled.
Note: If the installation CD software does not automatically start, be sure that
the computer CD-ROM drive door is completely closed. If the CD
software still does not start after the door is closed, use the following
steps to install the software:
a. Click Start.
b. Click Run.
c. Type x:\setup.exe where x is the drive letter for your CD-ROM
drive.
3. Follow the on-screen instructions to install the software. When the on-screen
instructions prompt you to connect the scanner to the computer, connect the
scanner using instructions given in "Connecting the scanner to the computer" on
page 1-5.
4. Restart your computer when prompted by the installation CD.
1-4 IdeaScan 2000 Color Flatbed Scanner User's Guide