Cradle Installation To The Host Device - Champ SG300RFM User Manual

3.5 Cradle Installation To The Host Device

RS232
1. Turn off the host device.
2. Connect the 10-pin RJ45 male connector into the 10-pin
modular jack on the bottom of the cradle.
3. Connect the 9-pin D-type Female connector of the RS232
cable to the proper COM port of the host device.
4. Plug the external power supply into the power jack on the
bottom of the cradle.
5. Plug the power supply into the AC outlet. The red LED on
the rear of the cradle will stay on.
6. Turn on the host device.
5