TASCAM MMR-8/MMP-16 Version 4.0 Table of Contents MMR-8 / MMP-16 V 4.0 U ....................2 ERSION PDATE MMR/MMP S ..................2 NSTALLING OFTWARE PDATE New Rescue Disk............................ 2 4.0 ........................... 3 HANGES IN ERSION ..................3 OOLS OLUME AND UTOMATION Volume Automation ..........................
MMR-8 and MMP-16. Installing The MMR/MMP Software Update To install software in an MMR-8 or MMP-16, first make sure the unit to be updated already has Version 3.0 or higher software installed (software installed from the two Rescue Disks is also acceptable).
! In and out Points set by last punch in non-destructive record Pro Tools Volume and Mute Automation Version 4.0 software for the MMR-8 and MMP-16 adds support for Digidesign Pro Tools volume (gain) and mute automation data on playback.
Gray out each audio track volume automation selector on which you desire to have volume automation disabled. Press save. The volume automation is disabled. In the example above: Track1.L will not play back any volume automation moves on the MMR/MMP while Track 1.R will. TASCAM MMR-8/MMP-16 Version 4.0 Owner’s Manual Update...
Version 4.0 adds support for the ViewNet Audio graphical interface network. Before the ViewNet Audio application can work with a TASCAM MM series machine, the proper network settings must be configured on the MM unit. Once the network settings have been configured, the MM series machine must be rebooted before these settings will take effect.
Other rules regarding numbers assigned to computers and MM series machines are given in the next section. TASCAM MMR-8/MMP-16 Version 4.0 Owner’s Manual Update...
Audio files created by the Zaxcom DEVA hard disk field recorder can be played on the TASCAM MM Series machines. These must be in the EBU standard Broadcast Wave format on a DOS-FAT16 formatted disk in a directory labeled /ZFILES. The name of the DEVA track files must conform to the naming conventions used by the DEVA recorder.
Clip Names for new audio recordings are now set when in non-destructive record mode. The name format for MMR-8 clips will show the track prefix, followed by a track take number that increments for each new track created, but will be the same for all clips created on a track, followed finally by a sequential clip number that increments each time a new clip is recorded.
Page 10
TEAC AUSTRALIA PTY., LTD. 106 Bay Street, Port Melbourne, Victoria 3207, Australia Phone: (03) 9644-2442 A.C.N. 005 408 462 TEAC ITALIANA S.p.A. Via C. Cantù 5, 20092 Cinisello Balsamo, Milano, Italy Phone: 02-66010500 TASCAM MMR-8/MMP-16 Version 4.0 Owner’s Manual Update...