Table of Contents
Advertisement
fitting the whisks/hooks
1 Switch off (0) before fitting or removing the whisks/hooks.
2 Align the pips on the shaft with the slots in the drive head.
3 Push the shaft into the drive head till it clicks into place.
4 Each whisk/hook must be fitted into a specific drive head.
5 The shaft with the flange fits the head with the large hole.
6 Use both whisks or both hooks, don't mix them.
removing the whisks/hooks
7 Switch off (0) and unplug the mixer, then shake any excess
mixture into the mixing bowl.
8 Hold both whisks/hooks, to prevent them jumping out,
then press 5 to eject them from the drive heads.
on/off switch
9 Slide the switch right to switch on (1), left to switch off (0).
10 When you switch on, the whole display will light up, then
it'll show "SPEED" at the top left, "0" in the centre, and
"TIMER 00:00" at the bottom.
speed buttons
11 Press and release u to increase the speed, till the speed
you want appears in the display.
12 Press and release d to decrease the speed.
13 Keep pressing to scroll quickly through the speeds.
14 The speed range is from 0 (stopped) to 16 (high speed).
15 The display will show "SPEED" at the top left, and the speed
(0 to 16) in the centre.
16 The figures below "TIMER" will show how long the motor
has been running, in minutes and seconds
17 To stop quickly, simply slide the on/off switch left (0).
the turbo button Y
18 Pressing the turbo button will over-ride the speed set by
the speed buttons, and give you a burst of high speed.
4
Advertisement
Table of Contents
