Quantum Qflash T4d Operating Instructions Manual page 9

5.3 Changing modes
To change from one mode to another:
Press Mode I button. The flash mode
display will blink.
Use Up J or Down L buttons to change
mode.
5.4 Changing settings in Manual mode
The camera exposure may be set to manual, or aperture or shutter
priority; however, Qflash will emit the fixed amount of light shown on
its display.
Press Set G one or more times until the parameter you wish to change
blinks. Set G will cycle through the displays for Manual Power Setting,
F#, and ISO, and Compensation (Section 9.0).
Then, press the Up J or Down L buttons to change the blinking parame-
ter. Note that as you change Power, F# or ISO the shooting distance
changes also.
For model X4d only there is an additional Manual setting for 200/400 watt
seconds, which can be set using the Options button, Section 5.9.
5.5 Changing settings in Auto mode.
The camera exposure may be set to shutter or aperture priority, or
manual when Qflash is set to Auto mode. Light output is controlled
by Qflash.
Press Set G one or more times until the parameter you wish to change
blinks. Set G will cycle through the displays for F#, ISO, and
Compensation (Section 9.0).
Then, press the Up J or Down L buttons to change the blinking parame-
ter. Note that the display shows the minimum to maximum flash distance,
and those distances change when you change F# or ISO. The F# also
may change when the ISO changes in order to keep you in the allowable
ranges of Qflash.
7