Hardware Features
WPS
PC to Extender
Status
Figure 1. Extender
The LEDs on the front show how the extender is working:
•
WPS. This LED indicates a WPS wireless connection.
-
Solid green. The wireless connection uses wireless security (WPA or WPA2).
-
Blinking green. A WPS connection is in progress.
•
PC to Extender. The LED is lit when the extender is connected to a computer.
•
Status. This LED is lit when the extender is powered on.
•
Link Rate. This LED indicates a wireless connection between the extender and the
router.
-
Green is best.
-
Amber is good.
-
Red is poor.
The side panel has the following features:
•
Ethernet port. You can use this port for a wired connection to a computer or other device.
•
Factory Reset button. To use this button, stick a paper clip into the reset hole and hold it
until the Status LED flashes.
•
WPS button. Press the WPS button to connect the extender to your wireless router.
•
Device On/Off button. This button turns the extender on and off.
N300RE WiFi Range Extender
Device On/Off button
WPS button
Factory Reset button
Ethernet port
Link Rate
Getting Started
5
Note: For best performance,
position antennas pointing up.