Restarting The Network - NETGEAR RP614 Installation Manual

Macintosh Operating System
Mac OS® 8.6 or 9.x
1. Choose Control Panels >TCP/IP
from the Apple () menu.
2. If not already selected, select Ethernet
in the Connect via list.
3. Select Using DHCP Server in the
Configure list.
4. Click the close box.
5. Click Save.
6. Go to Restarting the Network.
Mac OS X
1. Choose System Preferences from the Apple menu.
2. Double-click Network.
3. If not already selected, select Built-in Ethernet in the Configure list.
4. If not already selected, select Using DHCP in the TCP/IP tab.
5. Click Save.
6. Go to Restarting the Network.
Linux® or UNIX® Operating System
If you're installing the router with a Linux-based or UNIX-based computer, see your system
documentation to set up TCP/IP networking to obtain IP addresses automatically using DHCP.

Restarting the Network

Once you've set up your computer to work with the router, you must reset the network for the
devices to be able to communicate.
1. Turn off (or unplug) the DSL or cable modem and router.
2. Turn on (or plug in) the DSL or cable modem and wait until the lights indicate that
service is established again (1–2 minutes).
3. Plug in the router and wait until the Test light turns off (10 seconds).
4. Restart the computer that is connected to the router.
Note: If the Test light stays lit, go to Troubleshooting on page 11.
Mac OS 8.6/9.x
7