MAINTENANCE
Gear Housing
1. Clean all loose debris from gear box.
2. Remove plug (A) and check level of grease.
3. Add grease if necessary, DO NOT over-fill.
4. Install plug (A).
Drive Shaft
Lower and upper drive shaft must be lubricated with POWER BLENDX
operation, otherwise drive shaft assembly overheating and failure can result.
1. Remove gear housing locator screw (A).
2. Loosen gear housing mounting bolt (B).
3. Pull gear box from drive shaft housing.
4. Pull flexible cable from the drive shaft housing, wipe clean
and re-coat with a thin coating [15 ml (1/2 oz.)] of POWER
BLENDX
.
TM
5. Slide the flexible cable back in the drive housing. DO NOT
get dirt on the flex cable.
6. Position lower drive shaft (end without safety decal) into
gear housing shaft mount.
7. Align hole in drive shaft housing with gear housing shaft
hole (C), and seat lower drive shaft end into gear housing
shaft mount. Install and tighten locator screw (A).
8. Tighten gear housing mounting bolt (B).
16
99944200553
A
TM
grease every 25 hours of
A
C
B
X77702093405
© 08/2013 ECHO Inc.