Table of Contents
Advertisement
and hold the answer/end key for
about 2 seconds.
To end the active call on the second
connected device and make the call
on hold active on the first device,
press the answer/end key.
To switch between the active call on
second device and the call on hold on
the first device, press and hold the
answer/end key for about 2 seconds.
Clear settings or reset
To clear all the settings from the
headset, switch off the headset, and
press and hold the power key and
the answer/end key at the same time
for about 8 seconds. The headset
Product and safety information
Battery and charger
information
This device has an internal,
nonremovable, rechargeable battery.
Do not attempt to remove the battery
beeps twice, and the red and green
indicator lights alternate. After the
settings are cleared, the headset
enters pairing mode.
To reset the headset if it stops
functioning, even though it is
charged, connect the headset to a
charger while you press and hold the
power key.
Troubleshooting
If you cannot connect the headset to
your compatible device, make sure
that the headset is charged,
switched on, and paired with the
device.
from the device as you may damage the
device.
This device is intended for use when
supplied with power from the following
chargers: AC-3, AC-4, AC-5, AC-8, DC-4,
ENGLISH
Hide quick links:
Advertisement
Table of Contents
