Rane DEQ 60 Operator's Manual page 3

DEQ 60
MADE IN U.S.A.
RANE CORP.
ACN 001 345 482
U.S. PATENT 7,266,205
FOR CONTINUED
GROUNDING
PROTECTION
DO NOT REMOVE
BYPASS
SCREW
ALL
100-240V
50/60 Hz 20 WATTS
4
1 Channel A and B INPUTS: Plug the outputs of the mixer or other source to these Inputs. Choose between the XLR, the ¼" TRS, or the Eurob-
lock Input jack—use only one—they do not sum.
Rane adheres to the international and U.S. standard for balanced pin configurations: Pin 1 is chassis ground (neutral), pin 2 is hot (positive),
and pin 3 is signal return (negative).
Avoid the temptation to use unbalanced tip-sleeve ¼" TS plugs, but if you must, keep them short as possible, 10 feet (3 meters) maximum. Long
unbalanced cables invite hum, noise and other undesirables. Balanced TRS ¼" are much better at rejecting noise.
The Euroblocks normally connect the cable shield to the ground terminal. For those installations where the internal shield-to-chassis connec-
tion causes interference, connect each shield directly to the chassis grounding screw located above each Euroblock connector, keeping the shield
wrapped around the audio conductors as much as possible. For optimum Electromagnetic Interference (EMI) immunity, connect the shields at
both ends of the cable to chassis ground.
See the RaneNote "Sound System Interconnection" for more information on system connections and proper grounding practices.
2 Channel A and B OUTPUTS: Any Output can be used simultaneously with the others, take your pick. Same wiring as above...keep cables
short, always wire balanced when possible, eat your vegetables, yadda yadda.
3 BYPASS mode switch: See 5, Front Panel, previous page.
4 Power connector: Uses the standard cord provided. Inside the DEQ 60 is a universal internal switching power supply that accepts 100 to 240
VAC at 50 to 60 Hz, allowing it to work in most countries.
OUTPUT B OUTPUT A
+ -
+ -
COMMERCIAL AUDIO
EQUIPMENT 24TJ
R
FILTERS
3 2
The DEQ 60 and DEQ 60L rear panels are identical except in height.
REAR PANEL DESCRIPTION
INPUT B
+ - + -
+ - + -
1
INPUT A WIRING
TIP / PIN 2 = POSITIVE
RING / PIN 3 = NEGATIVE
SLEEVE = SIGNAL GROUND
PIN 1 = CHASSIS GROUND
+ -
+ -
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Manual-3