Yard-Man 31AE993I401 Operator's Manual page 7

simultaneously with the traction control, the operator
can release the auger control (on the left handle) and
the augers will remain engaged. Release the traction
control to stop the augers and wheel drive (the auger
control must also be released).
Always release the traction control before
IMPORTANT:
changing speeds.
Auger Control
The auger control is located on the left handle.
Squeeze the auger control to engage the augers.
Release to stop the snow throwing action. The traction
control must also be released in order to stop the auger.
Refer to Auger Control Test on page 9
IMPORTANT:
prior to operating your snow thrower. Read and follow
all instructions carefully and perform all adjustments to
verify your snow thrower is operating safely and
properly.
Shift Lever
The shift lever is located in the center of the handle
panel and is used to determine ground speed and
direction of travel. It can be moved into any of eight
positions. See Figure 7.
Always release traction the control before
IMPORTANT:
changing speeds.
Forward
Your snow thrower has six forward (F) speeds. Position
number one (1) is the slowest and position number six
(6) is the fastest.
Reverse
Your snow thrower has two reverse (R) speeds. R1 is
the slower, while R2 is the faster of the two.
Traction Control /
Auger Control Lock
Headlight
Fuel Tank
Discharge
Chute
Chute
Clean-out Tool
Auger
Chute Directional Control
The chute directional control is located on the left hand
side of the snow thrower. To change the direction in
which snow is thrown, turn the chute directional control
as follows:
•
•
Wheel Steering Controls
The left and right wheel steering controls are located on
the underside of the handles and are used to assist in
steering the snow thrower.
•
•
Headlight
The headlight is on whenever the engine is running.
Chute Clean-out Tool
This item is fastened with a cable tie to the rear of the
Auger Housing at the factory. Cut the cable tie before
operating the snow thrower.
The chute clean-out tool is designed to clear a clogged
discharge chute. Refer to page 9 for detailed
instructions how to properly use the chute clean-out
tool.
Shift Lever
Wheel Steering
Control
Skid Shoe
Figure 7
7
Turn clockwise to discharge to the left;
Turn counterclockwise to discharge to the right.
Squeeze the right wheel steering control when
turning right; squeeze the left control when turning
left.
Operate the snow thrower in open areas until
becoming familiar with these controls.
WARNING:
Never use your hand to clear
a clogged discharge chute. Shut off engine
and remain behind handles until all moving
parts have stopped before unclogging.
Auger Drive Control
Chute Tilt
Control
Chute Directional Control
Primer
Choke
Safety
Ignition Key
Throttle
Control
Electric
Starter
Button
Switch
Box
Recoil
Starter
Handle