Driver & Application Installation - Leadtek WinFast Quick Installation Manual

Driver & Application Installation
Notice:
Please make sure the WinFast TV USB II is powered on and the USB cable is properly
connected between PC and the device.
Step 1: When the
Step 2: Insert the software CD and click
WinFast TV USB II icon and select
Step 3: Select the language you use and click
Step 4: The WinFast TV USB II Installation
Click Next .
Step 5: When the Install Shield Wizard has completed the installation, check
want to restart my computer now
Warning messages may pop up several times
during the installation. Click
Anyway to proceed.
( The System may prompt you to install
Microsoft DirectX for updating purpose. Select
I accept the agreement
Follow the on-screen instructions and the
system will automatically reboot.) When the
driver installation is completed, click
Finish to restart the computer.
Step 6: After rebooting the computer, eject the CD and insert it again. Click
USB and move the cursor to the WinFast TV USB II icon. Select
Step 7: When the
language you use and then click
Step 8: The InstallShield Wizard shows the welcome message of the application
installation. Click
Step 9: A license agreement appears on the screen. Click
Step 10: InstallShield Wizard will next prompt you to choose the destination location for
the application. To use the preset location as shown in the lower part of the panel,
simply click Next
choose a location.
New Hardware Found
Continue
and Next
Choose Setup Language
OK
Next to start the installation of the application.
to go to the next step. If another location is desired, click
window flashes, dismiss it by clicking
WinFast TV USB.
Driver to start installation.
OK .
window pops to display welcome info.
and click Finish .
to install it.
YES and
dialog box appears again, select the
.
3
Move the cursor to the
Application
Yes to continue.
Browse
Cancel .
Yes, I
WinFast TV
.
to