Table of Contents
Advertisement
INSTALLLING YOUR VCR
AUTO INSTALLATION
6.
Press [
/
and press
SET
to confirm.
7.
Press [
/
and press
SET
to confirm.
8.
Ensure your AERIAL/SCART cable is
connected to your VCR and then press
SET
to confirm
9.
SAT CONTROL will be highlighted.
•
If you do have a satellite receiver
connected to the VCR continue from
10
point
.
•
If you do not have a satellite receiver
connected to the VCR leave SAT
CONTROL set to OFF and press
The VCR will attempt to copy the TV preset list (NexTView compatible TV's only). During the
copying process the display will show the TV presets that are being copied. If the VCR is
unable to copy the TV preset list the terrestrial channels will be automatically installed. (Auto
install may take a few minutes.)
On completion the MOVE menu will appear showing the preset channel order. By pressing the
Mode OSD
button, the VCR will change to a blue background. This may help you see which
channels your VCR has tuned in. Press
displayed on your TV screen for approximately
the clock screen will appear, refer to
If you wish to customise the channel order refer to
All the programmes should now be correctly tuned in and the clock
set.
Points 10-15. (Satellite/Cable Box Control only)
10.
Select Channel 1 on your satellite receiver.
11.
Press [
/
], to set SAT CONTROL to ON.
12.
Press [
/
If the VCR is not connected to the satellite receiver as shown previously:
i.
Your satellite receiver should be connected to the Antenna (RF in on the back of the VCR)
select RF IN using [
ii.
Press [
/
] to select CHANNEL.
iii.
Press [
]. The current channel will be displayed as a background to the on-screen
display. If this is not a satellite channel press [
channel. By pressing the
This may help you see which channel your VCR has tuned in.
] to select your language
] to select your country
SET
MENU
MANUALLY SETTING THE CLOCK
], to select INPUT. L2 will be highlighted.
/
] You will need to tune the VCR into the Satellite receiver.
Mode OSD
9.
S A T CON T RO L
➔
I N P U T
S A T NO .
P L E A S E CONN E C T - - - - -
S A T
- - - - - - - - - - -
: S E L E C T
S E T
: E N T E R
.
to exit. The correct Time and Date should be
2
seconds. If the clock is not automatically set,
MANUALLY SORTING CHANNELS
] again. Continue until you see a satellite
button, the VCR will change to a blue background.
GB-8
S A T R E C E I V E R
ON
R F I N
0 0 1
L 2
: CHANGE
ME NU : E X I T
.
O F F
L 2
V CR
.
Advertisement
Table of Contents
