Remote Control Operation Of Tv - Sharp VC-S2000GM Manual

ADVANCED OPERATION

REMOTE CONTROL OPERATION OF TV

In addition to operating the VCR the remote control will also operate basic functions on TVs,
including brands other than SHARP.
SETTING UP THE VCR REMOTE
CONTROL TO OPERATE THE TV
1.
Switch on the TV. Open the door on the
remote control and point the unit at the TV.
2.
Hold down TV BRAND SET
remote control and the appropriate
button for the TV from the list shown, for 2
seconds. For example for a SHARP TV, press
TV BRAND SET
3.
The TV will enter standby mode to confirm
the correct code has been entered.
4.
To turn the TV on from standby mode hold
TV BRAND SET
about 2 seconds.
CONTROLLING THE TV WITH THE VCR REMOTE CONTROL
TV OPERATE
•
TV INPUT SELECT
•
TV CH
• /
• TV VOL / +
• Certain models of TV do not use standard codes for their brand. In this case hold down
TV BRAND SET
mode (You will need to reset when remote control batteries are replaced).
• SHARP cannot guarantee the VCR remote control will operate your TV.
on the VCR
1
and .
and 1 (Sharp TV) for
Switches the TV to and from Standby Mode.
Determines which input to the TV is to be displayed on the
screen.
Changes the TV channels.
Increases or decreases the volume.
, then press each of the buttons in the list until the TV enters stand-by
TV BRAND BUTTON
SHARP 1
PHILIPS 2
THOMSON 3 or 4
GRUNDIG 5
FERGUSON 6
ITT NOKIA 7
SONY 8
GB-30
TV BRAND BUTTON
TOSHIBA 9
PANASONIC 0 or
HITACHI INPUT SELECT
SANYO MODE OSD
JVC DISPLAY
MITSUBISHI AUDIO OUT