Sharp VC-M35SM Manual page 31

TINS-3799UMZZ ENGLISH.book Page 31 Thursday, April 20, 2000 9:23 AM
TROUBLESHOOTING
TROUBLESHOOTING
AREA
REMOTE
CONTROL
OTHER
PROBLEMS
PROBLEM
The VCR can not be • Remote control is too far away from the main
operated by remote unit.
control • Point the remote control at the VCR.
• Batteries are flat - replace both.
• Batteries have not been inserted correctly.
• VCR is positioned in strong light.
Picture does not • Make sure the VCR is not in Timer or Menu
change even though mode.
CHANNEL
/ buttons
are pressed.
Desired channel • The channel position has been set to be
position can not be skipped. Cancel the SKIP mode for that
selected. channel.
No colour or poor TV • Make sure all the cables are connected
picture on normal properly.
viewing. • Make sure the VCR power cord is properly
plugged in.
Not possible to view • Make sure the RF OUTPUT has not been
picture or playback switched off. (Refer to note on RF THROUGH
through RF OUT. ON/OFF in the TUNING THE TV TO THE VCR
section of the manual.)
Desired channel has • Possible weak signal strength, the same
interference. channel with a better signal strength may
have been tuned in on another VCR preset
channel. Example;
VCR preset 1 = CH21 and
VCR preset 14 = CH21
(Refer to Manually Sorting Channels section
to move the channel to your desired
position.)
• TV aerial may need adjusting.
No picture appears. • Make sure the TV is on the video channel.
• Check all connecting cables.
GB-31
POSSIBLE CAUSE/CURE